Step Analysis for the Installation Process of Belt Conveyor

There are seven steps in the installation process of belt conveyors, here are some tips analyzed by experts from PK machinery.

1 .Installation of the belt conveyor landing leg and intermediate frame

Please confirm the Centerline by using the theodolite before installation, then according to the centerline to find pile point location of each landing leg. If there is embedded iron, adjustment should be made according to the location of the embedded iron in order to facilitate the installation, each landing leg should be firmly welded with the embedded iron.

2 .Installation of the counterweight device

In this process we need to ensure the parallelism between the two force columns, and meanwhile ensure its verticality. Considering the safety, protective railings shall be immediately installed after finishing the installation of this device.

3 .Installation of the headstock, tailstock and drive device base

Firstly we should verify the install elevation and confirm the centerline. Then pay attention to the sizing block location and its number not more than 5 blocks. The thinner sizing block should be placed among the thicker ones and be firmly welded.

4 .Installation of the roller and carrier roller

Before the installation, we should check the rotary condition of the bearing and repair or change it in time if there is any problems in the rotating.

5 .The Unit Installation

The unit axis deviation is 0.02 mm; the radial error of coupling is 0.05 mm, the Clearance between the half couplings is 3 ~ 5 mm. the levelness and usage of the sizing block should also meet the specification requirements.

6 .The belt installation

The belt installation should be operated by the manufacture or the professional.

7. Oil the belt conveyor and make debugging

If your want to view more,please click: www.pkbeltconveyor.com